Hanna Instruments (M) Sdn Bhd
11A, Jalan PJS 11/20,
Bandar Sunway,
46150 Petaling Jaya,
Selangor, Malaysia.
Penang Branch Office
Hanna Instruments (M) Sdn Bhd
N0. 303-2-27, Krystal Point,
Jalan Sultan Azlan Shah,
11900 Sungai Nibong,
Penang, Malaysia.
+604-638 4558
+604-645 4558
penang@hannamalaysia.com
Sabah Branch Office
Hanna Instruments (M) Sdn Bhd
No. 4-1, 1st Floor,
Block E, Plaza Kingfisher,
Jalan Plaza Kingfisher 5,
88450 Kota Kinabalu,
Sabah, East Malaysia.
088-382 941
088-382 942
sabah@hannamalaysia.com
Johor Branch Office
Hanna Instruments (M) Sdn Bhd
No. 49-1, 1st Floor,
Jalan Molek 3/10,
Taman Molek,
81100 Johor Bahru,
Johor, Malaysia.
+607-351 8998
johor@hannamalaysia.com
HI1006-1805 pH/Temp Industrial Smart Probes for HI-510 Controller
| Previous | 1 / 48 | Next |
Download Files
QR10X6-8_06_22.pdf (298.84 KB)MAN10X6-8_07_22.pdf (401.14 KB)
MAN10X6-8_04_22.pdf (570.89 KB)
pH and Temperature Industrial Smart Probes
HI510 and HI520 Universal Process Controller Compatible
These industrial pH probes are intended for industrial process control when paired with the HI510 or HI520 Universal Process Controller.
- HI1006-18 and HI1016-18 series, designed for low conductivity or low-temperature process environments
- HI1006-38 and HI1016-38 series, designed for extended pH range or high-temperature process environments
- HI1006-48 and HI1016-48 series, designed for process environments
An integral temperature sensor measures water temperature and adjusts the probe signal over the specified temperature range. The flat tip eliminates deposits that can foul the sensor and significantly reduces necessary maintenance. The PVDF body material is easy to clean and disinfect, and resistant to most chemicals (e.g. solvents, sodium hypochlorite), ultraviolet light, and fungal growth.
Suitable for continuous measurement of pH required in applications such as urban wastewater treatment, industrial effluent treatment, and surface water monitoring, the probe (and accessories) can be installed directly in-line, immersed in a tank, or in a flow cell. The probe is available with an integral connector that permits connections after installation. Patch cables may be purchased separately to connect between the probe and controller up to 50 meters (164 ft). Individual SKUs ending in the 00 suffix are supplied with a DIN connector (without cable). SKUs ending in the 05, 10, 15, 25, 50 suffixes include a patch cable, with the individual numbers representing cable length in meters (see the product manual in the Resources section below for more information).
Additional Features At-a-Glance
- Rugged, chemically-resistant PVDF body
- Specialized glass sensor for fast stabilization and accurate results
- 3/4'' NPT external thread for mounting
- Built-in temperature sensor for measurement and compensation
- Matching pin helps avoid typical problems caused by grounding loop current
- Digital probe stores model, firmware, serial number, and calibration information